①卷材屋頂防水層所用卷材及重要配套材料必須吻合設計要求。檢查出廠合格證、質量檢驗報告和現(xiàn)場抽樣試驗報告。
The coiled material and the main materials used in the waterproofing membrane must meet the design requirements. Check the factory certificate, quality inspection report and on-site sampling test report.

②卷材屋頂防水層在轉角處、變形縫、穿墻管道等部位做法必須吻合設計要求。
The practice of waterproof layer in the corner, wall cracks, pipeline and other parts must meet the design requirements.

③卷材屋頂防水層的搭接縫應粘（焊）結牢固，密封精密，不得有扭曲、皺折、翹邊和起泡等缺陷。

The waterproof layer of the lap joint should stick (welding) firm, tight sealing, no distortion, fold, curling and blister defects.

④采用外防貼法鋪貼卷材屋頂防水層時，立面卷材接槎的搭接寬度(關鍵詞排名)，高聚物改性瀝青類卷材應為150mm，合成高分子類卷材應為100mm（網(wǎng)站排名），且上層卷材應蓋過基層卷材。
The anti sticking paving waterproof layer, the facade coil joint lap width, polymer modified bitumen is 150mm, synthetic polymer materials should be 100mm, and the upper cover lower coil coil.

⑤側墻卷材屋頂防水層的保護層與屋頂防水層應結合緊密、保護層厚度應吻合設計要求。
The protective layer of the side wall waterproof layer and waterproof layer should be closely combined, the thickness of the protective layer shall comply with the design requirements.

⑥卷材搭接寬度的許可誤差為-10mm。
The coil lap width of the allowable deviation is -10mm.